Adaptec SAS RAID Controllers Instalační příručka stáhnout pdf (Strana 84)

70 Sun StorageTek SAS RAID HBA Installation Guide • March 2010

▼ To Start the ACU

tart the BIOS RAID Configuration utility.

See “To Start the BIOS RAID Configuration Utility” on page 68

2. If you have more than one HBA, select the HBA that you want to manage and

press Enter.

3. Select Array Configuration Utility and press Enter.

4. Follow the on-screen instructions to create and manage arrays, and initialize,

rescan, and erase disk drives.

▼ To Create a New Array With the ACU

Note – You can create an array with the ACU and the Sun StorageTek RAID

Manager graphical user interface (GUI). However, it is a much quicker process to

create an array through the GUI than the ACU. Creating an array with the ACU

might take two to three times longer than creating an array with the GUI. For more

information, see the Sun StorageTek RAID Manager Software User’s Guide.

1. Select Create Arrays from the main ACU menu.

Only disk drives that can be used in a new array are available for selection. (Disk

drives must be initialized before they can be used in an array. See “To Initialize

Disk Drives With the ACU” on page 72 for more information.)

2. Use the Array Properties menu to modify the RAID level, size, name, stripe

size, and caching settings of the array.

Note – For more information about RAID levels and using disk drives to create

arrays, see “Selecting the Best RAID Level” on page 91.

Note – Creating a new array might change the BIOS boot order. Check the BIOS

settings to verify the correct boot order. For more information, see “Best Practices For

Controlling the Boot Order of Logical Drives” on page 87.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 147 148

Žádné komentáře

Adaptec SAS RAID Controllers Instalační příručka Strana 84