Adaptec SAS RAID Controllers Instalační příručka stáhnout pdf (Strana 53)

CHAPTER

Installing an OS Onto a Bootable

Array on an x64 System

If you chose to create a bootable array on an x64 system as part of your installation

(see “Creating a Bootable Array on an x64 System” on page 27), you can install an

operating system and the HBA driver on that bootable array.

This chapter explains how to install an operating system (OS) onto a bootable array

and then install the HBA driver on the array.

Note – If you are using a SPARC system and you chose to create a bootable array as

part of your installation (“Creating a Bootable Array on a SPARC System” on

page 33), DO NOT perform any steps in this chapter. Instead, skip to “Installing the

Solaris OS on a SPARC System” on page 45.

Note – If you want to perform a standard installation on an existing operating

system, DO NOT perform the procedures in this chapter. Instead, go to “Installing

the Driver on an Existing Operating System” on page 49.

Note – Each computer system is different. The instructions in this chapter might

need to be modified, depending on your actual system configuration. See your

system documentation for more information.

This chapter contains the following sections:

■ “Preparing to Install an OS” on page 40

■ “Installing the HBA Driver With an OS” on page 40

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 147 148

Žádné komentáře

Adaptec SAS RAID Controllers Instalační příručka Strana 53