Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Instalační příručka Strana 63

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 86
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 62
Operating the SIERRA™ plus film digitizer 61
VIDAR Film Digitizer Installation Guide
3. Observe the LED on the front of the digitizer: the LED should flash
yellow for several minutes. This indicates the digitizer is performing
internal tests and calibration.
4. When the LED stops flashing and remains green, turn on the PC.
The digitizer is now ready to scan films.
Note:
Normally,
do not turn off the digitizer
. Leave it on
continuously. Turn the PC on and off as needed.
CAUTION:
X-ray images displayed on a computer monitor are
representative only. Dimensional and grayscale inaccuracies
may result from the build-up of tolerances in the digitizer, the
display board and the computer. For this reason, special
precautions must be exercised when taking measurements from
the digitized image. Please refer to the user’s manual for your
digitizing software for more information.
Zobrazit stránku 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 85 86

Komentáře k této Příručce

Žádné komentáře