Adaptec 2110S - SCSI RAID Controller Instalační příručka stáhnout pdf (Strana 53)

3-18

Adaptec RAID Installation Guide

Note: If you are not prompted for a PCI card or memory

controller driver, open the Device Manager. If the Device

Manager displays PCI Card with a yellow exclamation mark

in the Other Devices list, you might need a patch for your

motherboard chipset to recognize multifunction bridge

controllers. Contact your motherboard vendor and apply

the patch. After the patch is installed and the system is

restarted, Windows repeats the device discovery process.

Continue the procedure.

6 Select PCI Card and then select Update Driver from the Driver

tab.

7 Insert the driver disk you created earlier (refer to page 3-11)

and let Windows search for the drivers.

8 Windows should now identify the PCI card as Adaptec I

RAID Host Adapter. Select Finish. At this point, you might need

to force Windows to copy the driver from the floppy drive

instead of the CD drive.

9 When prompted regarding testing the device ROM, click

Cancel.

10 Open the Device Manager. If the Other Devices category shows

a PCI memory controller, select it, click the Driver tab, and

select Update Driver.

11 Let Windows search for the drivers from the driver disk you

created earlier (refer to page 3-11).

12 Windows should now identify the PCI memory controller as

Adaptec I

O Memory Adapter. Select Finish. At this point, you

may need to force Windows to copy the driver from the floppy

drive instead of the CD drive.

13 If your system contains multiple Adaptec RAID controllers,

repeat Steps 6 through 12 for each Adaptec RAID controller.

14 Restart the system and then open the Device Manager. It

should now show an Adaptec I

O RAID Host Adapter in the

SCSI and RAID Controllers section.

COMBINED RAID IG.BOOK Page 18 Tuesday, September 25, 2001 5:46 PM

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 105 106

Žádné komentáře

Adaptec 2110S - SCSI RAID Controller Instalační příručka Strana 53