Adaptec 2110S - SCSI RAID Controller Instalační příručka stáhnout pdf (Strana 39)

3-4

Adaptec RAID Installation Guide

Adding the Controller to an Existing System

In this scenario, you are adding an Adaptec RAID controller to a

system that already has a Windows 2000 operating system. To install

the driver

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

e Insert a floppy disk and click OK. The system creates the

driver disk.

2 Shut down the system and remove the Adaptec RAID

Installation CD and the driver floppy disk.

3 Install and configure your controller and hard drives according

to the instructions in Chapter 2.

4 Start Windows 2000. Windows launches the Found New

Hardware Wizard, which searches for the controller.

5 Insert the driver disk you created in Step 1.

6 Select the floppy disk as the source and then click Next.

7 Click Next in the succeeding two windows that appear and

follow the on-screen instructions to complete the controller

installation.

COMBINED RAID IG.BOOK Page 4 Tuesday, September 25, 2001 5:46 PM

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 105 106

Žádné komentáře

Adaptec 2110S - SCSI RAID Controller Instalační příručka Strana 39