Adaptec 2110S - SCSI RAID Controller Instalační příručka stáhnout pdf (Strana 47)

3-12

Adaptec RAID Installation Guide

Creating the Driver Disk

Each of the procedures for installing the driver in each case requires

a slightly different procedure. However, all the procedures require

you to create a driver disk. To create the driver disk

1 Insert the Adaptec RAID Installation CD in your drive.

2 Start from the CD. The CD loads a Linux kernel that is used to

manage all of its functions.

3 Follow instructions and respond to prompts as necessary to get

to the Adaptec splash screen.

4 When you see the Adaptec splash screen, click Create Driver

Disk. Then, click the appropriate operating system.

5 Insert a floppy disk and click OK. The system creates the

driver disk.

6 Shut down the system, and remove the Adaptec RAID

Installation CD and the driver floppy disk.

CD-ROM Support

Before you can install Windows, you need to verify that you can use

your CD drive to install Windows. Identify the scenario that applies

to your situation and follow the recommendations below:

■ If the CD drive plugs into the motherboard or is on an ATA

controller, use the Windows startup floppy disk included with

the Windows CD.

■ If the CD drive is on a SCSI controller other than an Adaptec

RAID SCSI controller, refer to the CD drive guide.

■ If the CD drive is on an Adaptec SCSI RAID controller, create a

driver disk for DOS in addition to creating a driver disk for

Windows as described in Creating the Driver Disk on page 3-12.

Use the DOS driver disk to execute

setupcd.exe to establish

CD-ROM support.

COMBINED RAID IG.BOOK Page 12 Tuesday, September 25, 2001 5:46 PM

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 105 106

Žádné komentáře

Adaptec 2110S - SCSI RAID Controller Instalační příručka Strana 47