Adaptec 2110S - SCSI RAID Controller Instalační příručka stáhnout pdf (Strana 48)

3-13

Installing the Driver

Installing the Driver in a New Windows 98/Me System

In this scenario, you doing a full installation on one disk drive or

array group using an Adaptec RAID controller in a new system. To

install the driver

1 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

2 Start up the system. During startup, press Ctrl+A to start

SMOR. Use SMOR to create the RAID. For details, refer to

Using SMOR on page 2-11.

3 Shut down the system and restart from a bootable DOS disk.

4 Run fdisk and create a primary DOS partition of an appropriate

size.

5 Mark the primary DOS partition Active.

6 Restart the system from the DOS disk.

7 Perform a system format by typing format c: \s.

8 Remove the start disk from the floppy disk drive and restart

the system from the

C drive.

9 Insert the Windows installation CD in the drive and type

d:\setup where d: is the letter assigned to your drive.

10 Follow the Windows installation prompts.

COMBINED RAID IG.BOOK Page 13 Tuesday, September 25, 2001 5:46 PM

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 105 106

Žádné komentáře

Adaptec 2110S - SCSI RAID Controller Instalační příručka Strana 48