Adaptec RAID 2810SA Uživatelská příručka stáhnout pdf (Strana 64)

A-11

Adaptec RAID Configuration Utility

displayed during system POST. Displaying the devices

adds a few seconds to the overall POST time.

To exit SATA

Select

, press

Esc

until a message prompts you to exit.

(If you changed any host adapter settings, you are prompted to

save the changes before you exit.) Select

Yes

to exit and restart the

system. Any changes you made take effect after the system boots.

Using the Disk Utilities

The disk utilities enable you to low-level format or verify the

media of your Serial ATA hard disks. To access the disk utilities:

1 Turn on your computer and then press Ctrl+A when prompted

to access the ARC utility.

2 If multiple controllers are installed, select the controller you

want to configure and then press Enter.

3 From the ARC menu, select Disk Utilities.

4 Select the desired disk and then press Enter.

You are offered the following options:

■ Format Disk—Simulates a format of the hard drive by

removing the file system and writing zeros to the entire disk.

Serial ATA drives are formatted at the factory and do not

need to be formatted again.

Caution: Formatting destroys all data on the drive. Be

sure to back up your data before performing this

operation.

■ Verify Disk Media—Scans the media of a disk drive for

defects. Any errors found are corrected.

Viewing the Event Log

The BIOS-based event log stores all firmware events (configuration

changes, array creation, boot activity, and so on).

The event log has a fixed size. Once full, old events are flushed as

new events are stored. Also, the log is volatile; therefore, it is

cleared after each system restart.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 152 153

Žádné komentáře

Adaptec RAID 2810SA Uživatelská příručka Strana 64