Adaptec RAID 2810SA Uživatelská příručka stáhnout pdf (Strana 32)

3-6

Installing the Driver

6 When prompted, insert the driver disk and then select OK.

7 Finish the installation procedures as appropriate for your

operating environment. Refer to the SuSE documentation for

details.

8 If you intend to install other third-party devices, proceed with

the installation of those devices. Otherwise, select Done.

9 Proceed with the Linux installation according to the Red Hat

instructions.

Installing the Driver in a New SuSE System

In this scenario, you are installing the controller in a new SuSE

Linux 8.1, 8.2 or SuSE Linux Enterprise Server 8 system. To install

the driver:

1 Install and configure the controller and hard drives according to

the instructions in Chapter 2.

2 Turn on the computer. During startup, press Ctrl+A to start the

ARC utility. Use the ARC utility to create the array. For details,

see Checking Your Controller and Devices on page 2-3.

3 Insert the first SuSE Linux distribution CD.

4 Restart the computer.

5 When the SuSE Linux installation screen comes up, press the

left ALT key.

6 When prompted, insert the driver disk.

7 Follow the SuSE instruction to configure your system for your

preferred environment.

Note: Some versions of SuSE Linux cause the driver to hang in

SMP (Symmteric Multi-Processors) machines. To prevent this

disable apic support. This can be done by typing

noapic

the GRUB loader command prompt.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 152 153

Žádné komentáře

Adaptec RAID 2810SA Uživatelská příručka Strana 32