Adaptec RAID 2810SA Uživatelská příručka stáhnout pdf (Strana 29)

3-3

Installing the Driver

Windows

The following sections describe procedures for installing the

controller with Windows 2000, Windows XP, or Windows

Server 2003. The following installation scenarios are described:

■ Installing the Driver in a New System on page 3-3

■ Adding the Driver to an Existing System on page 3-4

Installing the Driver in a New System

In this scenario, you are installing the controller in a new Windows

system. To install the driver:

1 Install and configure the controller and hard disk drives

according to the instructions in Chapter 2.

2 Start the system and then press Ctrl-A to enter the BIOS-based

configuration utility. Use the configuration utility to create the

array and logical drive to which you will install Windows. For

details, see Checking Your Controller and Devices on page 2-3.

3 After the array is built, insert the Windows setup CD and restart

the system to begin the Windows installation.

4 When prompted to install a third-party driver, press F6

Note: When F6 is active, a prompt appears at the bottom of

the screen for only 5 seconds. If you miss your chance to

press F6, restart the computer.

5 Insert the driver disk and wait until prompted to install a

driver. Press S to specify that the driver is on the floppy disk,

and then press Enter. The computer reads the disk.

6 When the Adaptec driver is found, press Enter. Follow the

on-screen instructions, responding as needed to complete the

installation.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 152 153

Žádné komentáře

Adaptec RAID 2810SA Uživatelská příručka Strana 29