Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Technické informace stáhnout pdf (Strana 41)

Chapter 2 Deploying the MetaFrame Servers and ICA Clients 27

You can install Windows 2000:

Using the Windows 2000 boot diskettes

Over an existing Windows NT or a Terminal Server/MetaFrame installation

using the Winnt32.exe program

From a DOS prompt using the Winnt.exe program

Citrix recommends using the boot diskettes provided with Windows 2000 to

perform the installation because you can then partition and format the target hard

disk drives as necessary. The other two methods do not support reformatting of

the drive containing the installation files.

Use one of the other methods only if you do not have a CD-ROM drive on the

server and want to perform the installation across the network. In that case, boot

the server in DOS, format the system partition, and then install Windows 2000

across the network, converting the drive to NTFS from FAT in the process.

If the installation disks, also called boot diskettes, that are supplied with Windows

2000 are misplaced or lost, you can create them on an existing Windows NT,

Windows 2000, W

INFRAME, or MetaFrame server using either the Makeboot.exe

or MakeBT32.exe executable from the Windows 2000 CD, as follows:

1. Have four blank, formatted, high-density 3.5-inch floppy disks ready. Label the

formatted disks “Setup Boot Disk,” “Setup Disk#2,” “Setup Disk#3,” and

“Setup Disk#4.”

2. Insert the Windows 2000 CD in the CD drive.

3. At a command prompt, change to the \Bootdisk directory on the CD-ROM.

4. Once in this directory, type either Makeboot or MakeBT32 and press

ENTER.

5. When prompted, insert the Setup Boot Disk in drive A. After some files are

copied, you are prompted to insert Setup Disk #2, Disk #3, and then Disk #4.

To install a fresh copy of Windows 2000 using the boot diskettes, perform the

following steps:

1. Insert the Windows 2000 Setup Boot Disk into the server’s drive A and start

the server.

An installation screen appears.

2. Setup gives you a choice of autodetecting the mass storage devices or selecting

them manually. In the latter case, Setup allows you to manually select SCSI

adapters, CD-ROM drives, and special disk controllers by pressing F6 for

installation. Citrix recommends that you allow Setup to autodetect the devices.

3. Insert disks #2 through #4 in drive A. Setup loads the drivers for Windows

2000 installation to boot Windows NT.

Tip

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 185 186

Žádné komentáře

Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Technické informace Strana 41