Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Technické informace stáhnout pdf (Strana 171)

Chapter 7 Troubleshooting the System 157

The symbols for the MetaFrame server and hotfixes must be installed in the

proper order so that the symbols match the executable files. The host system must

have the same MetaFrame server and hotfix symbols installed, but it does not

require the same software configuration.

Hardware Requirements

Local Debug Session

Null-modem cable between host and target computers

Remote Debug Session

Modems and modem cables for host and target computers. The host computer

is usually preconfigured and is at the support provider’s site. The target

computer requires a modem configured to allow dial-in access to the target

system. Citrix recommends using the U.S. Robotics Sportster series 56Kbps

modem.

ICA Debug Session

Null-modem cable between host and target computers

Modems and modem cables for host and remote client computers. The host

computer must have a connection configured in Citrix Connection

Configuration

Configuring the Target Computer for Debugging

The procedure for configuring the target computer is similar for both local and

remote debugging. The only difference is that remote debugging requires you to

place the modem attached to the debugging port into auto-answer mode.

There are four steps to the setup process:

Installing hotfixes

Installing symbols

Preparing the modem and/or COM port

Modifying the Boot.ini to enable kernel debugging

Installing Hotfixes on the Target Computer

See “Applying Server Hotfixes and Service Packs” in Chapter 6, “Maintaining

MetaFrame.”

Note

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 185 186

Žádné komentáře

Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Technické informace Strana 171