Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Technické informace stáhnout pdf (Strana 157)

Chapter 6 Maintaining MetaFrame 143

6. Assign the custom queue list to an interface. This step applies to serial ports so

the command refers to the serial interface (s0). The first entry designates the

serial interface while the second assigns custom queue 1 to the interface (s0).

From the Router#(config) prompt, type:

int s0

custom-queue-list 1

To determine if the changes have taken effect, use the show interface (s0) or

the show queuing command.

Troubleshooting

If a priority or custom queue is not working properly, follow these directions:

Unassign the queue from the ports for which it is configured. In interface setup

configuration, type the following:

1. If a priority is set up, from Router(config-if)#, type:

no priority-group 1

2. If a custom queue is set up, from Router(config-if)#, type:

no custom-queue-list 1

This immediately removes the policy from that interface until a problem is

determined. Repeat the procedure from the (config) mode to actually remove the

queues, inserting the word “no” in front of the commands to reverse them. Run

show running-config to verify that changes were made. Make sure you copy to

startup-config using copy running-config startup-config when changes are

acceptable.

Packeteer (PacketShaper)

PacketShaper comes in three configurations.

The PacketShaper 1000 manages WAN connections at speeds up to 384Kbps

The PacketShaper 2000 handles WAN and Internet connections at speeds up to

10Mbps

The PacketShaper 4000 supports WAN and Internet connections at speeds up

to 100Mbps

Typically a PacketShaper is located at the remote side just outside of the

CSU/DSU to manage the data flowing in and out of the remote location. You can

access PacketShaper through a Web interface, a Telnet command line interface, or

a console session. PacketShaper identifies traffic, in this case port 1494, traveling

in both directions and prioritizes that traffic in a way that allows ICA traffic to get

through on the busiest of WANs. PacketShaper can be easily set up.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 185 186

Žádné komentáře

Adaptec 2940U - AHA Storage Controller Ultra SCSI 20 MBps Technické informace Strana 157