Adaptec SATA AND SCSI RAID CONTROLLERS Uživatelský manuál stáhnout pdf (Strana 97)

C-4

Adaptec Flash Utility (AFU)

3 Start the AFU as described in Running the AFU from the GUI on

page C-4 and follow the prompts.

Running the AFU from the GUI

The easy way to run the AFU is to use its Graphical User Interface

(GUI). If you prefer to run the AFU from the command line, see

page C-5.

To access the AFU:

1 Create the firmware floppy disks, as described in Creating the

Firmware Floppy Disks on page C-3.

2 Shut down your operating system and reboot to DOS from a

bootable MS-DOS floppy disk or from a DOS partition on a

bootable drive. (You can use the drive connected to the

controller you are updating.)

Note: When you are updating the controller flash, no I/O is

possible. Before you can use the controller again, complete

the flash operation and restart the computer.

3 At the DOS command prompt (typically

A:\>), type

AFU

with no

arguments.

The AFU’s main menu is displayed.

Choose

Select Controllers

and select the Adaptec RAID

controllers to be flashed.

5 Choose Select an Operation.

6 Choose any available AFU function and follow the on-screen

instructions.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 164 165

Žádné komentáře

Adaptec SATA AND SCSI RAID CONTROLLERS Uživatelský manuál Strana 97