Adaptec APA-1480 Uživatelský manuál stáhnout pdf (Strana 7)

C H A P T E R

Installation

The APA-1480 Enabler may be installed either in CONFIG.SYS,

AUTOEXEC.BAT or started from DOS command line. It’s possible to relocate

enabler into upper memory using DEVICEHIGH or INSTALLHIGH statements

in CONFIG.SYS.

The APA-1480 Enabler provides several command line switches allowing fine-

tuning of the driver. In more complicate cases you may create an initialization

file with very detailed configuration instructions.

It is recommended that you fine-tune CardBus Enabler switches starting

CardBus Enabler from the command line. After switches are set, you can place

call of CardBus Enabler either to CONFIG.SYS or to AUTOEXEC.BAT.

Deployment

In order to use SCSI devices (such as JAZ drive or CD-ROM) you typically will

need to load APA-1480 Enabler, Adaptec ASPI manager ASPI8DOS.SYS and

driver for your device. E.g. usage of CD-ROM requires ASPICD.SYS; usage of

SCSI Disk – ASPIDISK.SYS, etc. ASPI manager and required drivers could be

found in the Adaptec EZ-SCSI package.

However APA-1480 Enabler may provide support of Adaptec APA-1480

SlimSCSI CardBus cards and SCSI devices without load any additional drivers.

For use CD-ROM you will also need to load MSCDEX.EXE in your

AUTOEXEC.BAT.

If you are trying to use SlimSCSI with IOMEGA JAZ device we recommend

that you be using IOMEGA GUEST.EXE application rather then stack of ASPI

drivers. It gives more compact image on the floppy.

You can invoke APA-1480 enabler in the any point. For example:

…

DEVICE=C:\CB1480.EXE

DEVICE=C:\DOS\HIMEM.SYS /TESTMEM:OFF

DEVICE=C:\DOS\EMM386.EXE NOEMS

DOS=HIGH,UMB

Example of

config.sys

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Žádné komentáře

Adaptec APA-1480 Uživatelský manuál Strana 7