Adaptec AHA-2930CU Instalační příručka stáhnout pdf (Strana 20)

12 Setting up

VIDAR Film Digitizer Installation Guide

Terminate the SCSI bus

The film digitizer has two SCSI port connectors, enabling it to be placed

in the middle or at the end of a SCSI chain. VIDAR strongly

recommends that you install the digitizer at the end of a SCSI chain,

and that you not

change the factory SCSI termination setting.

Note: If you cannot install the digitizer at the end of a SCSI

chain, please contact VIDAR Technical Support for instructions

(+1.703.471.7070 or medtech@vidar.com).

Note: When the film digitizer is at the end of the SCSI chain,

the SCSI termination switch must be set for SCSI termination.

Consult your SCSI controller manual regarding proper use of

termination.

WARNING: Do not connect two SCSI controllers (i.e., two

computers) to the digitizer.

If you determine that the film digitizer’s SCSI termination is set for no

internal termination (lower picture below), here is how to change the

setting to activate internal termination:

1. Locate the SCSI termination switches

on the back of the digitizer (location is

shown on the next page).

2. Slide Switch 1 to the up position.

(Switch 2 has no function.)

Switch 1 set

for

internal

termination

Switch 1 set

for internal

termination

Factory (recommended)

termination switch setting

Not recommended

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Žádné komentáře

Adaptec AHA-2930CU Instalační příručka Strana 20