Adaptec AHA-2930CU Instalační příručka stáhnout pdf (Strana 19)

Setting up 11

VIDAR Film Digitizer Installation Guide

If necessary, set the digitizer’s SCSI ID

A computer equipped with a SCSI bus can communicate with multiple

SCSI devices (for example: a film digitizer, a scanner and a disk drive).

Each device must have a unique SCSI ID number so the computer can

distinguish it from other SCSI devices. Valid SCSI ID numbers range

from 1 to 6.

When selecting SCSI ID numbers:

 The SCSI Card 2930U is preset to SCSI ID 7 and should not be

changed.

 Set the film digitizer to any SCSI ID between 1 and 6, as long as that

number is not used by another SCSI device attached to the computer.

Note: The digitizer is shipped from the factory with the SCSI

ID preset to 3.

 If the system is configured to boot from a SCSI disk drive, it’s best to

set the disk’s SCSI ID to 0 or 1. Most SCSI disks are preset to SCSI

ID 0 at the factory.

CAUTION: The digitizer and computer MUST be turned OFF

before changing the SCSI ID.

To set the digitizer’s SCSI ID:

1. Locate the SCSI ID switch on the back of the

digitizer between the SCSI port connectors.

2. Change the SCSI ID switch using a 1/8" flat

blade screwdriver.

Note: Do not set the switch to position 0, 7, 8 or 9.

CAUTION: Do not force switch rotation. Do not use a large

screwdriver to rotate the switch.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Žádné komentáře

Adaptec AHA-2930CU Instalační příručka Strana 19