Adaptec 9110G Specifikace stáhnout pdf (Strana 13)

Installing the Hardware

Figure 4. Installing the Cable

Removing the GBIC

To remove the GBIC, follow these steps:

1 Remove the Fibre Channel cable.

a If you are using the IBM optical GBIC, flip the bar of the

GBIC to the OPEN position and pull to remove. See Figure 5

on page 10.

b If you are using the HSSDC copper cable, squeeze the tab on

the cable to remove. See Figure 6 on page 10.

c If you are using the HSSDC or the DB9 copper GBIC,

squeeze the tabs on both sides of the GBIC. See Figure 6 on

page 10 or Figure 7 on page 10.

d If you are using the DB9 copper cable, loosen the screws on

either side of the cable connector and pull out to remove.

See Figure 7 on page 10.

2 Pull the module out of the receptacle.

Copper (DB9)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Žádné komentáře

Adaptec 9110G Specifikace Strana 13