Adaptec RAID 2810SA Instalační příručka stáhnout pdf (Strana 3)

° Interrupted rebuilds may continue on the wrong drive

- Removing and reinserting an array's drive while the array is

still building/clearing may result in unpredictable status

being reported for any and all of the controller's arrays.

- You cannot move drives containing an array/volume from one

controller to another while power is on. Move drives by

powering off both affected controllers; relocating the drives;

and powering on the controller/drives at the new location.

Failure to do this can result in loss of configuration or

data or both.

- When you display information on a physical device,the vendor

and model information may be displayed incorrectly.

- After building or verifying a leg of a second level array,

the status of the second-level array displays as a Quick

Initialized array.

- In a situation where a RAID-10 is degraded, the BIOS reports

an error message that says degraded RAID-0 and degraded

RAID-1 (instead of degraded RAID-10).

- You can not change the priority of a RAID-10 verify. Setting

the priority at the start of a verify has no effect. The

priority is still shown as high. Changing the priority of

a running verify on a raid-10 changes the displayed priority

until a rescan is done, then the priority shows as high again.

- SATA events are displayed with SCSI nomenclature.

- If you experience problems with your video display or mouse

when using the Adaptec CD as the boot media for a system,

you'll need to specify your hardware by typing the following

at the command prompt:

bootcd [options] <Enter> or lowres [options] <Enter>

lowres forces the bootcd to use a generic framebuffer of 640x480

fbdev forces the bootcd to use a generic framebuffer of 800x600

options:

° m=<mouse type>

° s=<video server type>

° mon=<monitor value>

° p=<port> fbdev

° <mouse type>

man (for manual configuration, or

serial: generic, thinking, logitech, logitechcc, msnew,

msintelli, mousesystems, mmseries, mmhittab

non-serial: alpsps/2, atibm, geniusnmps/2, geniusnsps/2,

thinkingps/2, logibm, logimman+ps/2,

msintellips/2, msbm, usb

° <port> is a number from 1 to 4 representing com1..com4

1 2 3 4 5 6 7 8 9

Komentáře k této Příručce

Žádné komentáře

Adaptec RAID 2810SA Instalační příručka Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Software Adaptec RAID 2810SA