Adaptec RAID 2810SA Instalační příručka Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 9
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
--------------------------------------------------------------------
2. Installation Instructions
2.1. Software
The storage management software distributed with the Adaptec
2810SA is Adaptec Storage Manager-Browser Edition. Install
Adaptec Storage Manager-Browser Edition on Windows or
Linux platforms as detailed in the product documentation
provided on the CD in PDF format.
2.2. Hardware
Hardware installation instructions are also detailed in the
product documentation.
--------------------------------------------------------------------
3. General
- The Adaptec 2810SA allows you to import arrays or
legacy volumes created using the Adaptec 1210SA and 2410SA
RAID controllers.
- Although the Adaptec management utilities allow the creation
of RAID-50's with the Adaptec 2810SA, this RAID level is not
supported at this time.
- RAID 10 with 16k stripe size is not supported. An attempt to
create a RAID 10 with a 16k stripe size results in an error.
- RAID 10 with two or more degraded legs will rebuild the legs
sequentially, not simultaneously.
- When morphing a RAID 1 or RAID 5 to a RAID 0, and the original
array had a spare drive attached, the RAID 0 that results after
the morphing operation continues to have the spare drive
attached.
- The Adaptec 2810SA does not support PCI-Hotplug.
- Adaptec recommends that you do not run Adaptec Storage Manager-
Browser Edition and CLI (Command Line Interface) at the same
time.
- After pulling a hot spare and successfully building it into a
redundant array, information about the hot spare drive may not
display as expected. Adaptec Storage Manager-Browser Edition
may continue to display it as a global hot spare. CLI may
continue to display it as a global spare, but the array will
not have a spare attached. ARC (the BIOS utility) displays the
spare attached to the array as expected.
- Attach only new drives to the Adaptec 2810SA. New drives are
either drives that are being used for the first time, or used
drives that have been initialized or low-level formatted.
Attaching used drives may result in problems such as (but not
limited to):
° Existing/rebuilding arrays may go off line
Zobrazit stránku 1
1 2 3 4 5 6 7 8 9

Komentáře k této Příručce

Žádné komentáře