Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Technické informace Strana 110
- Strana / 188
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
100 Netfinity and Windows 2000 Integration Guide
Figure 85. The ASM processor shows up under the System Devices section. The ASM PCI Adapter is
visible once under Multifunctional adapters (enabled) and once under System devices (not started).
The Ports section displays the ASM serial port.
At this point, the device driver for the ASM hardware is installed and operational.
If you ever need to update the driver, right-click the device, select Properties,go
to the Driver tab and click Update Driver...
6.2.2 Adding an ASM PCI adapter separately
When you insert an ASM PCI Adapter after the operating system has been
installed, Windows 2000 will detect it the next time it is booted and bring up the
Found New Hardware Wizard as shown in Figure 86. Follow the on-screen
installation instructions, which are identical to the procedure outlined above.
The ASM PCI driver will
not start if the ASM
processor is also installed.
This is normal behavior.
The IBM Netfinity Advanced System Management PCI Adapter and the IBM
Netfinity Advanced System Management Processor both use the IBMSPW.SYS
driver. When both the processor and PCI adapter are installed, only the
processor will start up; the PCI adapter will have a status of not started. This is
normal behavior.
Note
- SG24-5319-00 1
- February 2000 3
- Contents 5
- Comments welcome 10
- Chapter 1. Introduction 11
- 1.1 IBM and Microsoft 12
- Chapter 1. Introduction 3 13
- Chapter 1. Introduction 5 15
- Windows NT 4.0: 16
- Chapter 1. Introduction 7 17
- Figure 2. Computer Management 17
- 2.1 Netfinity models 19
- 2.1.3 Netfinity 3000 22
- Table 3. Netfinity 3000 23
- 2.1.4 Netfinity 3500 M10 24
- Table 4. Netfinity 3500 M10 25
- 2.1.5 Netfinity 4000R 26
- Table 5. Netfinity 4000R 27
- 2.1.6 Netfinity 5000 28
- Table 6. Netfinity 5000 29
- 2.1.8 Netfinity 5600 32
- Table 8. Netfinity 5600 33
- 2.1.9 Netfinity 7000 M10 34
- Table 9. Netfinity 7000 M10 35
- 2.1.10 Netfinity 8500R 36
- Table 10. Netfinity 8500R 37
- 2.2 ServeRAID SCSI adapters 38
- 64/32-bit PCI Connector 39
- 32 MB EDO Cache 39
- LED Connector 39
- Battery-Backup Cache Slot 39
- 2.2.3 LVDS SCSI connectivity 40
- 2.2.4 ServeRAID adapter cache 41
- 2.3 Fibre Channel products 42
- Ethernet Port 45
- Serial Port 45
- Power Supply #1 45
- Port 7Port 0 45
- Power Supply #2 45
- 2098-02a 47
- 2.3.6 Fibre Channel cables 48
- Figure 24. Netfinity EXP200 49
- 2.5 Netfinity Director 50
- ASM interconnect 56
- Internal ASM 56
- © Copyright IBM Corp. 2000 49 59
- © Copyright IBM Corp. 2000 51 61
- Free update package 62
- Figure 32. The main menu 65
- Figure 35. Available programs 67
- Figure 40. General Setup 72
- Figure 42. Network Setup 73
- Virus alert 75
- 4.3 Replicated installations 76
- 4.4 What’snext? 76
- SMP support 78
- 5.1 SCSI disks 79
- 5.2 ServeRAID-attached disks 80
- 5.3 SMP support 83
- Figure 49. Processor options 84
- 5.4 Installing Windows 2000 85
- Figure 53. Regional Settings 87
- Figure 56 88
- Figure 59. Network Settings 90
- For more information 94
- © Copyright IBM Corp. 2000 85 95
- Figure 67. The Driver tab 97
- Important 102
- 6.2.3 Using the ASM hardware 111
- 6.4 PCI Hot Plug 113
- 6.5 Disk management 119
- 6.5.1 Basic and dynamic disks 120
- ServerGuide users 122
- Figure 100. Create Volume 123
- 6.6 Creating a repair disk 126
- Figure 106. ERD creation 127
- Figure 110. Device Manager 130
- Figure 114. Show all hardware 132
- Figure 115. Performance 135
- 7.1 System Monitor 136
- Monitoring disk activity 137
- Figure 119. Chart view 139
- 7.4.1 Adding objects 140
- 7.4.2 Deleting objects 141
- 7.5.1 Creating a counter log 142
- Figure 126. New counter log 143
- Figure 127. Log Files tab 144
- Figure 128. Schedule tab 144
- Selecting a time frame 145
- Chapter 8. Capacity Manager 147
- Report Definitions 148
- 8.4 Monitor Activator 150
- 8.5 Report Generator 151
- Figure 137. Monitor Selection 155
- 8.5.3 Generating a report 157
- 8.6 Report Viewer 159
- 8.6.1 Setting thresholds 160
- 8.6.2 The System pane 161
- 8.6.3 The Monitor pane 163
- 8.6.4 The Graph pane 163
- 8.7 Performance analysis 166
- 8.7.1 Reports produced 167
- 8.7.2 Types of bottlenecks 168
- Highlighted monitors 169
- 8.7.4 Forecast 170
- Figure 152. Forecast graph 171
- Appendix A. Special notices 173
- B.1 IBM Redbooks publications 175
- B.2 IBM Redbooks collections 175
- B.3 Referenced Web sites 175
- How to get IBM Redbooks 177
- IBM Redbooks fax order form 178
- List of abbreviations 179
- , 30, 40 183
- , 61, 76 183
- IBM Redbooks evaluation 187
- Printed in the U.S.A 188
Související produkty a manuály pro Servery Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps
Servery Adaptec ARO-1130U2 Uživatelská příručka
(152 stránky)
(152 stránky)
Servery Adaptec 1450 Specifikace
(162 stránky)
(162 stránky)
Servery Adaptec 210 Uživatelská příručka
(74 stránky)
(74 stránky)
Servery Adaptec 110 Specifikace
(16 stránky)
(16 stránky)
Servery Adaptec AAA-UDMA Instalační příručka
(66 stránky)
(66 stránky)
Servery Adaptec ARO-1130SA Manuál s instrukcemi
(86 stránky)
(86 stránky)
Servery Adaptec SANbloc S50 Instalační příručka
(20 stránky)
(20 stránky)
(52 stránky)
Servery Adaptec ASR-71605Q Uživatelský manuál
(9 stránky)
(9 stránky)
Servery Adaptec ASR-5405Z Uživatelská příručka
(6 stránky)
(6 stránky)
Servery Adaptec SANbloc S50 Instalační příručka
(20 stránky)
(20 stránky)
Servery Adaptec ASR-6805 Uživatelská příručka
(8 stránky)
(8 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.040 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce