Adaptec AVA-2825 Instalační příručka stáhnout pdf (Strana 3)

AVA-2825 Installation Guide

Part Number: 510612-00, Rev A

Print Spec Number: 492733-00

Current Date: 6/8/94 ECN Date: 6/14/94

Default Settings

The AVA-2825 default settings are as follows:

■ Many of these settings can be changed with the

SCSISelect configuration utility. See Configuring

the Host Adapter on page 8 for more information.

■ For information on changing the SCSI I/O port

address, see Changing the SCSI I/O Port Address on

page 4.

■ For information on changing the BIOS address

and the floppy drive controller setting, see the

table on page 3.

This is the IDE Mode 0 data transfer rate. You can achieve higher IDE data trans-

fer rates if you have an enhanced IDE disk drive and you install the FLEXI-Driver

software.

Parameter Default Setting

Host Adapter Interrupt Channel IRQ 11

Host Adapter SCSI ID 7

SCSI Parity Checking Enabled

Host Adapter Termination Enabled

Host Adapter BIOS Address DC000h

Enable Sync Negotiation Enabled

Enable FAST SCSI Enabled

Enable Disconnection Enabled

System Boot (INT 19h) Controlled by Host

Adapter BIOS

Enabled

Extended BIOS Translation for Drives >1 GByte Disabled

BIOS Support for Floptical Drives Disabled

SCSI I/O Port Address 340h–35Fh

IDE Data Transfer Speed 3.3 MBytes/sec

Floppy Drive Controller Enabled

1 2 3 4 5 6 7 8 ... 11 12

Žádné komentáře

Adaptec AVA-2825 Instalační příručka Strana 3