Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Uživatelská příručka stáhnout pdf (Strana 329)

100

101

9A-38 A-63054 February 2004

If you use the Split option, the documents must be folded according to the

following folding schemes:

When splitting images, Capture Software always assumes the first image

(image 1 in the diagram above) is on the front after scanning. If, during

scanning, the first image is on the rear side, be sure to enable the Swap Front

and Rear option just above the Merge and Split tabs.

Set the Auto-Rotate option (at the top of the Page Setup dialog box) correctly

depending on how you scan the document.

After split, images 1, 3, and 5 will be considered front images and images 2, 4,

and 6 will be considered rear images.

Because Capture Software immediately shows the result after merging or

splitting, you can test your page setup and make changes if necessary.

NOTES: Splitting images is not supported when color scanning with a Color

Scanner 3590C, Color Scanner 4500, or the i800 Series Scanners

(i.e., i820 Scanner and i840 Scanner).

If you are scanning in simplex mode (or when you are scanning

from the Scanner 1500 flatbed), the split will occur only on the front

image. Only a two-image split is supported with the with the following

folding scheme:

Both image 1 and image 2 will be considered front images.

4 1

2 3

1 2

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 411 412

Komentáře k této Příručce

Žádné komentáře

Adaptec 1542CP - Storage Controller Fast SCSI 10 MBps Uživatelská příručka Strana 329

Komentáře k této Příručce