Adaptec 9210LP Instalační příručka stáhnout pdf (Strana 31)

Installation Guide

When the uninstallation is completed, rebuild the kernel by

typing the command:

# /etc/conf/bin/idbuild -B

Press Enter.

Reboot the system to make sure the system boots correctly. Type

the command:

# init 6

The following sequences will happen after the init 6

command is issued:

• Terminates running services.

• Save your /stand/unix to /stand/unix.old then

• copy the new kernel from /etc/conf/cf.d/unix to /stand/unix.

• reboot system.

If System Crashes after Installing or Removing the

Driver in a Running UnixWare System

You may have to boot from the backup kernel created earlier and

then perform the driver update/removal procedure again. To

boot from the old kernel, follow these steps:

Reboot the computer.

At the Booting UNIX System... prompt or loading UnixWare

graphics, press the Spacebar. This will take you into a boot

prompt.

STEP 3

STEP 4

STEP 1

STEP 2

9210IG.book Page 30 Monday, April 2, 2001 11:13 AM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Žádné komentáře

Adaptec 9210LP Instalační příručka Strana 31