Adaptec 9210LP Instalační příručka stáhnout pdf (Strana 25)

Installation Guide

Remove the floppy disk after the driver loads. The drives are now

ready to be configured using the normal network administrator

access to create volumes and/or partition the drives. The

startup.ncf file can be modified to load the driver automatically

whenever the server is rebooted.

Unloading the Driver

To remove or update the driver, perform the following steps:

Confirm that there is no Fibre Channel activity occurring by

dismounting the drive.

Switch to the Command Console.

To dismount the drive, type:

DISMOUNT VOLUME_NAME

Press Enter.

To remove the driver, type:

UNLOAD AFC9XXX.HAM

Press Enter.

When the driver is successfully removed, an acknowledgement

from the system displays the message:

driver unloaded

The controller card is now deactivated.

STEP 3

The old driver must be removed before installing the

new one.

NOTE

STEP 1

STEP 2

STEP 3

The volume_name is the volume that the user has

created. If more than one volume needs to be dismounted,

perform the Dismount command for each individual volume.

NOTE

STEP 4

9210IG.book Page 24 Monday, April 2, 2001 11:13 AM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 36 37

Žádné komentáře

Adaptec 9210LP Instalační příručka Strana 25