Adaptec GDT8546RZ Uživatelská příručka stáhnout pdf (Strana 13)

Hardware Installation and User’s Guide 13

Hardware Installation

Figure 2-3. Installing the ICP RAID Controller into a Computer System

2.1.3 Changing Jumper Settings

The ICP RAID controller normally comes ready to be installed into the computer

motherboard immediately. However, jumper settings are available to:

• Reprogram the RAID firmware that is located in the flash memory of the ICP RAID

controller.

• Set the PCI bus speed (force 33 MHz or auto-negotiate 33/66 MHz).

The board contains 2 jumper blocks to control the functions described in Table 2-1

(GDT8546RZ) and Table 2-2 (GDT8586RZ). See Figure 2-2 (GDT8586RZ) or Figure 2-4

(GDT8546RZ) for jumper locations and pin numbers, and see Appendix A for a detailed

description of jumper J1 / FRU jumper.

PCI

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Žádné komentáře

Adaptec GDT8546RZ Uživatelská příručka Strana 13