Adaptec 39320-R Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Karty / adaptéry rozhraní Adaptec 39320-R. Adaptec 39320-R Installation guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 14
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
INSTALLATION GUIDE
ADAPTEC SCSI CARD 39320
ASC-39320 IG.fm Page 14 Monday, August 12, 2002 9:36 AM
Zobrazit stránku 0
1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - INSTALLATION GUIDE

INSTALLATION GUIDEADAPTEC SCSI CARD 39320ASC-39320 IG.fm Page 14 Monday, August 12, 2002 9:36 AM

Strany 2 - INTRODUCTION

9Connect the other external SCSI devices by linking each device to the previous one, as shown below. Terminate only the device at the end of the chain

Strany 3

10If you have any problems while installing the Adaptec SCSI Card 39320, check the following items first:•Are all SCSI devices powered on?•Are all SCS

Strany 4

11Copyright© 2002 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

Strany 5 - SETTING UP SCSI DEVICES

12This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inte

Strany 6 - CONNECTING SCSI DEVICES

© 2002 Adaptec, Inc. All rights reservedPart Number: 513280-06, Ver. AA JG 08/02RASC-39320 IG.fm Page 13 Monday, August 12, 2002 9:36 AM

Strany 7 - Nonterminated end

1The Adaptec SCSI Card 39320 enables you to connect up to 30 SCSI devices—such as very large arrays of high-performance hard disk drives, external sto

Strany 8

2Support for Older SCSI DevicesIf you have single-ended Ultra SCSI and earlier SCSI devices, Adaptec recommends that you connect them together on one

Strany 9

3After you turn off your computer and unplug the power cord, remove the cover from the computer.Locate an unused 64-bit PCI/PCI-X expansion slot and r

Strany 10 - Terminated SCSI device

4Insert the Adaptec SCSI Card 39320 in the 64-bit (or 32-bit) PCI or PCI-X expansion slot; press down firmly until the card clicks into place, then re

Strany 11 - TROUBLESHOOTING

5The Adaptec SCSI Card 39320 is preset to ID 7 for each channel and should not be changed. If you boot from a SCSI hard disk, make sure the hard disk

Strany 12 - Disclaimer

6The Adaptec SCSI Card 39320 has two separate Ultra320/160 SCSI channels, as shown in the figure on page 1. Both channels have an internal LVD/SE conn

Strany 13 - Canadian Compliance Statement

7Plug the nonterminated end of the cable(s) to one of the internal LVD/SE connector.Plug the internal Ultra320/160 and Ultra2 SCSI devices to the othe

Strany 14

8Connecting External SCSI DevicesYou can connect external Ultra320/160 and Ultra2 SCSI devices to the 68-pin external LVD/SE SCSI connector. Each exte

Komentáře k této Příručce

Žádné komentáře