Adaptec 39160 Instalační příručka stáhnout pdf (Strana 8)

Installation Guide

You can connect a total of 30 SCSI devices to the Adaptec SCSI

Card 39160,with up to 15 devices on each SCSI channel. Before

connecting devices, be sure to review

Setting Up SCSI Devices

page 4.

Connecting Internal Ultra160 and Ultra2 Devices

A special 68-pin internal LVD cable is needed to connect internal

Ultra160 or Ultra2 SCSI devices. If your cables are not marked,

you can identify most LVD cables as having twisted pairs of the

flat ribbon cable between the device connectors. Some cables are

laminated so that they lay flat. Internal LVD cables usually have a

terminator built into the end of the cable.

The Adaptec SCSI Card 39160 has two separate Ultra160 SCSI

channels, as shown in the figure on page 1. Each channel has an

internal LVD/SE connector to which you can connect internal

SCSI devices. Follow these steps to connect your internal

Ultra160 and Ultra2 devices:

Locate a 68-pin internal LVD SCSI cable, which may have either

twisted wires or flat wires, as shown here.

ONNECTING

SCSI D

EVICES

We recommend that you keep your Ultra160 and

Ultra2 SCSI devices on a separate SCSI channel from your

Ultra SCSI devices. This allows the newer Ultra160 and

Ultra2 SCSI devices to transfer data at their maximum speed.

OTE

TEP

Terminated end

Non-terminated end

39160_OEM_InsGd.book Page 6 Thursday, October 14, 1999 10:18 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Žádné komentáře

Adaptec 39160 Instalační příručka Strana 8