Adaptec ASH-1233 Uživatelská příručka stáhnout pdf (Strana 13)

Connecting Your ATA Disk Drives

The ASH-1233 adapter supports up to four ATA disk drives in a

master/slave configuration. (See Setting Jumpers on ATA Disk Drives

on page 5 for more information.)

Connect each ATA disk drive to the ASH-1233 adapter using the

proper 40-pin IDE cable.

Note:

The Adaptec ASH-1233 adapter does not support Cable

Select (CSEL) settings

. You must change the jumper settings

to set drives as master or slave.

To connect your ATA disk drives, follow the instructions for your

specific drive configuration:

■ To install an ATA disk drive as the only device on a cable, see

page 7.

■ To install two ATA disk drives on the same cable, see page 8.

Connector (to Master)Connector (to Slave)

onnector (to Adapter)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Žádné komentáře

Adaptec ASH-1233 Uživatelská příručka Strana 13