Adaptec AHA-1510B Instalační příručka stáhnout pdf (Strana 8)

AHA-1510B Installation Guide

Part Number: 511023-00, Rev. A Page 7 of 12

Print Spec Number: 494546-00

Current Date: 3/11/96

Last Modified: March 11, 1996 12:57 pm

File Location: n:\suz\1510b\1510bnug.fm

ECN Date: 3/19/96

Setting Host Adapter Switches

The switch block on your host adapter is factory set to

work in a Plug and Play system. Since resources in a

Plug and Play system are assigned automatically, you

should not have to change these settings.

If your system is not Plug and Play, you may have to

change the I/O port address and Active/Inactive set-

tings. The table below lists all possible settings on the

switch block.

■ Host Adapter Active/Inactive—If your system has a

Plug and Play operating system but does not have a

Plug and Play motherboard BIOS, you should choose

Inactive; otherwise, choose Active.

■ Host Adapter I/O Port Address—If your system is

Plug and Play, the I/O port address is set automati-

cally. If your system is not Plug and Play, you should

choose an I/O address range that does not conflict

with the I/O address range of another device installed

in your system.

Do not use this setting in Legacy/Non-Plug and Play systems.

SCSISelect Utility

Configuring the Host Adapter

The SCSISelect configuration utility allows you to change

host adapter and SCSI settings without having to open the

computer or handle the board. SCSISelect also contains

utilities that allow you to low-level format or verify the

disk media of your SCSI hard disk drives.

The SCSISelect settings are listed in the table below. If you

want to view and/or change the current settings, or if you

would like to format or verify a disk, see Starting the

SCSISelect Utility on page 8. Detailed descriptions of each

setting begin on page 9.

Host Adapter Active/Inactive sw1 sw2 sw3

Active Off Off Off

Inactive

Off On On

Reserved All Other Switch Settings

Host Adapter I/O Port Address sw4

340-35F Off

140-15F On

(Open = Off)

1 2 3 4

OPEN

Basic Host Adapter Settings

Host Adapter Interrupt (IRQ) Channel

Host Adapter SCSI ID

SCSI Parity Checking

Host Adapter SCSI Termination

SCSI Device Settings

Initiate Sync Negotiation

Maximum Sync Transfer Rate

Enable Disconnection

Advanced Host Adapter Settings

ISA Plug and Play Support

Plug and Play SCAM Support

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Adaptec AHA-1510B Instalační příručka Strana 8

Komentáře k této Příručce

Související produkty a manuály pro ne Adaptec AHA-1510B