Adaptec 2940UW Uživatelská příručka stáhnout pdf (Strana 21)

2-9

Installation

Install the host adapter device driver, as described in the

following section.

Installing the Device Driver (Version 2.0 or Later)

for Solaris/SPARC 2.5.1 or 2.6

You can install AHA-2940UW/OF and AHA-2944UW/OF device

drivers either from a floppy disk or from the Adaptec Web Site.

Follow the procedures below to install the device drivers.

Installation from a Floppy Disk

Log on to the Solaris operating system as root.

Insert the 7800 Family Open Firmware Manager Set, v2.0 device

driver installation diskette into the floppy drive.

At the superuser prompt (#), type the following command and

press Enter:

/etc/init.d/volmgt stop

Then type the following and press Enter:

pkgadd -d /dev/fd0

The following software package is displayed:

Select the package by typing 1 or all and pressing Enter to

install the device driver.

Press Y to answer yes to each question that follows.

When the following message is displayed, type q to quit the

installation:

Installation of <ADPadp> was successful.

Reboot the system to enable the new device driver to take

effect.

1 ADPadp Adaptec 294X(U)W/394X(U)W/4944(U)W SCSI

Host Adapter Driver

(UltraSparc) release v2.00

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 49 50

Žádné komentáře

Adaptec 2940UW Uživatelská příručka Strana 21