Adaptec 1742A Uživatelský manuál stáhnout pdf (Strana 2)

| FCO CHARGING INFORMATION (See Last Page) |

|______________________________________________________________________________|

| APPROVALS |

|______________________________________________________________________________|

|_________________|____________________|___________________|___________________|

|Brenda Rogers | MARCH 1994 | B | 22-APR-94 |

|_________________|____________________|___________________|___________________|



+---------------------------+ |

| d | i | g | i | t | a | l | |

+---------------------------+ |

_________________________________|______________________________________

 INSTRUCTIONS FOR INSTALLING

FCO PB22H-O002 on ADAPTEC 1742A SCSI CONTROLLER

 Product Family PB22H-CX and PB22H-KB

 ************************** REFERENCE ************************

 For more detailed information and illustrations, please refer

to the DECpc AXP 150 and DEC 2000 Model 300 AXP Hardware

Service Information Manual, Order Number: EK-A0637-SV. This

document is also available on TIMA, in the "Tools" section.

 Chapters of interest include:

 Chapter 4, Section 4.11, Updating the Firmware

 Chapter 6, Using The EISA Configuration Utility

 Chapter 9, Removal and Replacement

*************************************************************

GUIDELINES



The upgrade consists of four major steps as follows:

1 - Record NT and or VMS/OSF Bootstrap settings.

2 - Replace the PROM on the ADAPTEC 1742A SCSI controller.



3 - Perform the console firmware update for OpenVMS/OSF1.

4 - Run the ECU program.

PROCEDURE

o - Before turning off power to the system, make sure to record the NT

 and /or VMS/OSF bootstrap settings.

 For the NT console, it is most important to record the NT bootstrap

 settings, as it could very difficult to determine these settings

Adaptec 1742A Uživatelský manuál Strana 2