Adaptec 2410SA - Serial ATA RAID Controller Instalační příručka Strana 1

ADAPTEC SERIAL ATA RAID 2410SAENCLOSUREHARDWAREINSTALLATION GUIDE2410SA Enclosure Kit HIG.fm Page 0 Thursday, October 23, 2003 1:20 PM

9Adaptec Customer SupportIf you have questions about installing or using your Adaptec product, check this document first—you will find answers to most

10Europe Visit our Web site at www.adaptec-europe.com. German: To speak with a Technical Support Specialist, call +49 89 43 66 55 22, Monday to Frid

11Limited 3-Year Hardware Warranty1. Adaptec, Inc. (“Adaptec”) warrants to the purchaser of this product that it will be free from defects in material

12Regulatory Compliance StatementsFederal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this un

Adaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035 USARPart Number: 513760-03, Rev. A LB 10/03Printed in Singapore©2003 Adaptec, Inc.All righ

1In this Guide...This Hardware Installation Guide explains how to set up the 4-bay hot-swappable drive chassis included in the Adaptec® 2410SA Enclosu

2Installing the Drive CarriersTo install a drive carrier:1 Mount a hard disk drive in a drive carrier and secure it with screws, as shown.2 Insert the

3Labelling the Drive CarriersThe four drives are designated slightly differently by the Adaptec 2410SA controller, the drive chassis, and the Adaptec

42 Turn the drive chassis so that you can access the connectors on the rear panel.3 Using the Figure as a guideline, connect the cables. Use gentle bu

54 Install the drive chassis into the computer cabinet, using the screws provided in the Adaptec 2410SA Enclosure kit. (Your computer cabinet may not

69 Power on your computer and install the device driver for the Adaptec Serial ATA RAID 2410SA controller, if you haven’t already. Refer to the Adapte

73 Mount a new drive in a drive carrier and secure it with screws, as shown in Step 1 on page 2.4 Insert the drive carrier into the drive slot and pus

8Copyright©2003 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any