Adaptec 2200S - SCSI RAID Controller Instalační příručka stáhnout pdf (Strana 31)

2-12

Adaptec SCSI RAID 2120S/2200S Installation Guide

On step 3 of 3, type the name you wish to assign to the RAID 5

you are creating, then click Finish.

A pop-up window appears, notifying you that the system is

creating the array in hardware. When it disappears, the display

will refresh. It will look the same as it did originally, with the

addition of showing the RAID 5 you’ve created appearing on the

right side of the display as a dynamic icon with a 5. You may use

the array immediately, but you may wish to allow the array to

finish building before restarting the system, especially if you are

going to install the operating system to the new array.

When you are ready to continue, close the Mozilla window that is

the active browser. You are back on the Main Menu. If desired, you

may wish to review other documentation before proceeding.

Click Reboot to restart your system. Remove the CD when the

system ejects it.

You may now use the system as you normally would, with the

three drive RAID 5 acting as a logical drive. You may install an

operating system to this drive, or use the RAID 5 as you would any

disk drive.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 66 67

Žádné komentáře

Adaptec 2200S - SCSI RAID Controller Instalační příručka Strana 31