Adaptec 2010S - SCSI RAID Storage Controller Instalační příručka stáhnout pdf (Strana 18)

2-1

Installing Your Controller

In this Chapter

Configuring SCSI Devices

When configuring devices for Adaptec ZCR controllers, you may

need to:

■ Decide how to position drives on the SCSI bus.

■ Select cables.

■ Enable or disable SCSI termination.

■ Set the SCSI IDs.

Note: SCSI drives should, in general, not be reformatted.

However, if your SCSI drive was formatted to a sector size

other than 512 bytes, you must reformat the drive before you

can use it in a RAID. Refer to the Adaptec Storage Management

Software User’s Guide for details.

Configuring SCSI Devices 2-1

Installing the Controller 2-5

Creating an Array Using SMOR 2-6

Determining the Booting Controller 2-7

R2N2 RAID IG.BOOK Page 1 Monday, September 9, 2002 12:01 PM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Žádné komentáře

Adaptec 2010S - SCSI RAID Storage Controller Instalační příručka Strana 18