Adaptec FS4500 - Hard Drive Array Uživatelská příručka stáhnout pdf (Strana 22)

2-4

Installing the Storage Enclosure

Installing into a Rack

Begin the installation by ensuring that you have all these rail kit

components:

■ Front rails (1 left, 1 right)

■ Rear rails, two different sizes (2 left, 2 right)

■ Two sizes of screws (10 large, 4 small)

■ Two types of nuts (10 of each)

To install your Storage Enclosure in a rack:

1 Secure the front rails to the front supports of the rack, using the

supplied screws, as shown in Figure 2-1.

Note: Use either the speednuts or cagenuts provided if

your rack does not have threaded holes.

Figure 2-1 Securing the Rails to the Rack

2 Check the length between the front and rear supports of your

equipment rack and determine which set of rear rails to use, the

long or the short.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 90 91

Žádné komentáře

Adaptec FS4500 - Hard Drive Array Uživatelská příručka Strana 22