Adaptec ICP5045BL Uživatelská příručka stáhnout pdf (Strana 53)

Chapter 7: Installing the Driver and an Operating System ● 53

Installing with FreeBSD

Note: You will need your FreeBSD Installation CD to complete this task.

To install the driver when installing FreeBSD:

1 Insert the FreeBSD Installation CD.

2 Restart your computer.

3 When the FreeBSD start screen opens, select 6 to escape to loader prompt.

4 Type

load kernel

5 Insert the driver floppy disk.

6 Type

load disk0:aacu.ko

If the driver fails to load, run lsdev and check for the floppy disk drive. Then, try again with

the appropriate device.

7 Type

boot

8 Complete the FreeBSD installation, following the instructions included with your

operating system.

9 Reboot your computer, then remove the driver disk.

10 Repeat Steps 3 through 7 the first time you boot the operating system to load the drivers

again for the initial bootup.

Note:

Currently, ICP Storage Manager is not supported on FreeBSD. To create and manage

arrays, use the

ICP RAID Configuration utility. See page 62 for more information.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 134 135

Žádné komentáře

Adaptec ICP5045BL Uživatelská příručka Strana 53