Adaptec P2280A Instalační příručka Strana 8

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 28
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 7
English
Installing the Ultra160 SCSI Adapter Card
4 English
Installing the Ultra160 SCSI Adapter Card
For complete instructions on how to install an adapter card, refer to
your PC’s documentation. The following steps are guidelines only.
WARNING For your safety, never remove the PC’s cover without first removing
the power cord from the power outlet and any connection to a
telecommunications network. Always replace the cover before
switching the PC on again.
1 With the PC turned off, disconnect the power cord and any
connection to a telecommunications network, and then remove
the cover.
2 Choose an empty PCI slot. If you do not know how to identify a
PCI slot, refer to your PC’s documentation.
3 Depending on the PC model, you may need to remove the
accessory slot’s retaining bracket. Refer to your PC’s
documentation if necessary.
4 Insert the Ultra160 SCSI adapter card into the PCI accessory slot
without bending it.
5 Ensure that the adapter card is properly seated, then connect the
SCSI LED cable to the connector on the SCSI adapter card and
the connector marked “SCSI LED” on the system board.
NOTE “SCSI LED” connector on the system board is only present on some
systems.
6 Replace the slot’s screw or retaining bracket, as appropriate.
7 Replace the cover. Reconnect the power cord and any
connection to a telecommunications network.
The adapter card may be
installed in a minitower or
desktop model.
p2280a.book Page 4 Thursday, May 17, 2001 5:00 PM
Zobrazit stránku 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Komentáře k této Příručce

Žádné komentáře