Adaptec AHA-1542B Uživatelská příručka stáhnout pdf

INTRODUCTION

I-E97-811-1C 2 - 1

SECTION 2 - INSTALLING ADAPTER CARDS

INTRODUCTION

NOTE:

The instructions in this section apply to AT-type computers

ONLY. AT-type computers are 80286, 80386, 80486 and Pentium

based IBM PC/AT-compatible computers.

PC HARDWARE INSTALLATION CONSIDERATIONS

Every time you use a PC and install utility cards in the slots

provided, you run the risk of conflicts with the hardware.

NOTE:

It is critical that you understand your hardware. We recom-

mend you to have a list of the interface cards and other devices as

well as the interrupts and memory locations used by each. This

information is needed during Startup as you are configuring each

node.

HARDWARE SETTINGS

Many of the cards you insert in your computer's expansion

slots require hardware settings. These settings are:

•

ROM addresses

•

I/O port addresses

•

Interrupts

•

DMA channels

Settings are usually selected using jumper pins or dipswitches

on the interface card.

The settings you make for each adapter card must not conflict

with the settings on any other card.

Follow Tables 2-1 through 2-4 to choose the settings for the

adapter cards of commonly installed peripherals.

WARNING

Always turn off power to the computer and disconnect the

power cord when inserting adapter cards in your computer.

CAUTION

Always wear a conductive groundstrap when handling adapter

cards to prevent damage to components by electrostatic dis-

charge.

1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1 - HARDWARE SETTINGS

INTRODUCTIONI-E97-811-1C 2 - 1SECTION 2 - INSTALLING ADAPTER CARDSINTRODUCTIONNOTE: The instructions in this section apply to AT-type computersONLY

Strany 2

INSTALLING ADAPTER CARDSNETWORK CARDS2 - 10 I-E97-811-1C®Using the following procedure to start the DOS based setupprogram to configure the ALTA Eth

Strany 3

INSTALLING ADAPTER CARDSADAPTEC 1540B/1542B SCSI HOST ADAPTER CARDI-E97-811-1C 2 - 11The card has a dipswitch in the upper left corner of the card

Strany 4

INSTALLING ADAPTER CARDSADAPTEC SCSI HOST ADAPTER CARD: MODEL 1540C/1542C/1542CF2 - 12 I-E97-811-1C®from pin 1 on J8. This will allow the computer&a

Strany 5

INSTALLING ADAPTER CARDSADAPTEC SCSI HOST ADAPTER CARD: MODEL 1540C/1542C/1542CFI-E97-811-1C 2 - 13•Change the ROM address from the factory setting

Strany 6

INSTALLING ADAPTER CARDSADAPTEC SCSI HOST ADAPTER CARD: MODEL 1540C/1542C/1542CF2 - 14 I-E97-811-1C®The Main Menu allows the user to access one of C

Strany 7

INSTALLING ADAPTER CARDSADAPTEC SCSI HOST ADAPTER CARD: MODEL 1540C/1542C/1542CFI-E97-811-1C 2 - 15NOTE: The “Host Adapter SCSI Termination” should

Strany 8

INSTALLING ADAPTER CARDSMKM/EMKI KEYBOARD SWITCHING2 - 16 I-E97-811-1C®Press <Esc> to return to the Configure/View Host Adapter Set-tings Menu

Strany 9

INSTALLING ADAPTER CARDSHARDWARE SETTINGS2 - 2 I-E97-811-1C®Switch settings for the following recommended computers areto be found in Appendix C:HP

Strany 10 - INSTALLING ADAPTER CARDS

INSTALLING ADAPTER CARDSHARDWARE SETTINGSI-E97-811-1C 2 - 3I/O PortsInput output ports (I/O ports) allow your microprocessor tocommunicate with you

Strany 11

INSTALLING ADAPTER CARDSHARDWARE SETTINGS2 - 4 I-E97-811-1C®InterruptsMost cards need to tell the processor when they have informa-tion for the proc

Strany 12

INSTALLING ADAPTER CARDSVIDEO ADAPTER CARDSI-E97-811-1C 2 - 5Usually IRQ7 is not used by the printer, as printers seldomsend data to the computer,

Strany 13 - Off/Open

INSTALLING ADAPTER CARDSSERIAL AND PARALLEL PORTS2 - 6 I-E97-811-1C®only two thirds of the graphics display appears on the screen),reboot the comput

Strany 14

INSTALLING ADAPTER CARDSNETWORK CARDSI-E97-811-1C 2 - 7NETWORK CARDSEthernet Network CardIf you are setting up an Ethernet network, you will need o

Strany 15

INSTALLING ADAPTER CARDSNETWORK CARDS2 - 8 I-E97-811-1C®•Locate the entry for the PCI Integrated Ethernet Interface,refer to the computer's Use

Strany 16

INSTALLING ADAPTER CARDSNETWORK CARDSI-E97-811-1C 2 - 9ALTA EtherCombo-16 T/CThe ALTA is an ISA bus, NE1000/NE2000 compatible ethernetcard. All con

Komentáře k této Příručce

Žádné komentáře

Adaptec AHA-1542B Uživatelská příručka

Procházejte online nebo si stáhněte Uživatelská příručka pro Síťové přepínače Adaptec AHA-1542B. Adaptec AHA-1542B User`s guide [en] Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Síťové přepínače Adaptec AHA-1542B