Adaptec 131U2 - AAA RAID Controller Manuál s instrukcemi Strana 64

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 82
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 63
A-2
AAA-130U2 Series Installation and Hardware Guide
SCSI
Select
Default Settings
The SCSISelect default settings for the AAA-131U2/133U2, listed in
the table below, are appropriate for most systems. If you want to
view and/or change the current settings, or if you would like to for-
mat or verify a disk, see Starting the SCSISelect Utility on page A-3.
Detailed descriptions of each setting begin on page A-5
.
SCSI
Select
Option Available Settings Default Settings
SCSI Bus Interface Definitions
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled/Disabled Enabled
Host Adapter SCSI Termination
Channel A:
ULTRA2-LVD/SE Connector
Fast/Ultra-SE Connector
Channels B & C:
(AAA-133U2 only)
Auto/Enable/Disable
Enable/Disable
Enable/Disable
Auto
Enable
Enable
SCSI Device Configuration
Initiate Sync Negotiation Yes/No Yes (Enabled)
Maximum Synchronous Transfer Rate 80.0
1
, 53.3
1
, 40.0,
32.0, 26.6, 20.0,
16.0, 13.4, 10.0
1
If Initiate Wide Negotiation is set to No, this setting is not available.
80.0
2
2
If Initiate Wide Negotiation is set to No, the default setting is 40.0.
Enable Disconnection Yes/No Yes (Enabled)
Initiate Wide Negotiation Yes/No Yes (Enabled)
Send Start Unit Command Yes/No Yes (Enabled)
Include In BIOS Scan Yes/No Yes (Enabled)
Additional Options
Array1000U2 BIOS Enabled/Disabled Enabled
BIOS Support for Bootable CD-ROM Enabled/Disabled Enabled
Zobrazit stránku 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 81 82

Komentáře k této Příručce

Žádné komentáře